Talk to Us +44 (0)20 8378 3200
Bollards
Brochure PDF's
Technical
Bollards F1 Removable Sockets
Furnitubes F1 Removable Sockets
Furnitubes F1 sockets provide a neat solution for locations where fire brigade padlock access is not required.
The sockets are designed to accept a bollard of either 75 or 115mm diameter. They are based around a heavy-duty cast-iron body with a hole to accept the bollard and a separate hole to access the special retention bolts.
Canterbury Removable Bollard with Large F1 115 Socket
CTB 930R & F1 115
Composite Removable Socket
Cast Iron Lid
To accept bollards of ø115 mm diameter
Options:
F1 75 socket
Small F1 75 Socket Operation
F1 75
1) To access the retention bolts, remove the locking lid of the F1 75. This is done by inserting the aluminium key and turning it anti-clockwise.
2) Next, undo the single retention bolt and remove the damaged Bollard.
3) Insert the Bollard, so that it is resting on the base of the socket. Then tighten the retention bolt fully to secure the Bollard. Finally replace the locking lid.
Large F1 115 Socket Operation
F1 115
1) (A screwdriver is required for this procedure) Firstly remove the lid of the F1 115 by tuning the screw anti-clockwise until the lid can be removed.
2) Next, make sure the stainless steel Bollard protector is installed, insert the Bollard until it is resting on the base of the socket.
3) To secure the Bollard, tighten both retention bolts fully. The F1 115 has the space to store the pedestrian plug within the cavity. Finally replace the lid.