Bell 115 Cast Iron Bollard with the Linx Railing System

BELL115 & LINX100

OTHER INFORMATION

TESTIMONIALS

"Furnitubes Bell Bollard has certainly stood the test of time, we have a few in the borough that have been installed for at least a decade and are still going strong!"
Phil Greet, Highways Engineer, London Borough of Havering

Q50 Site/ street furniture/ equipment

30 STREET FURNITURE

190 BOLLARDS

Q41 Barriers/ guardrails
135 PROPRIETARY PROTECTIVE BARRIERS

The Bell® 115 has been designed to allow the installation of a Bell Bollard and a 115mm diameter post or bollard within the same footings. The combination will deflect vehicles and protect structures from damage, whilst also acting as a high visibility post.

The ability of the Bell 115 to act as a pedestrian barrier is further enhanced by incorporating the Bell Bollard into the Linx™ 100 railing system. By combining the two products it is possible to design an integrated, cost effective vehicular and pedestrian barrier, with the Bell Bollard protecting any corner post from damage by passing vehicles.

SPECIFICATION

Bell Bollard

475 mm above ground
1180 mm over height with LINX railing
450 mm below ground
600 mm diameter ground profile with offset hole to accommodate 115 mm diameter post (supplied separately)

MATERIAL & FINISH

Cast iron - primed finish
Standard finish is primer. We recommend that top coats are applied on site after installation.

DOWNLOADS

bell cast iron bollard data sheet.pdf

PRODUCT NOTES

Bell Bollards
All rights reserved.
Bell Shaped Traffic Bollards in this or other forms, with or without surface decoration are Copyright Protected (filed in accordance with Universal Copyright Convention in London) & may not be reproduced without the prior permission of Furnitubes International Limited or the original Copyright holder.

Registered at Stationers’ Hall, London.
No B9/1082/3602

BACK TO CATALOGUE