Telescopic Bollard Range
The Telescopic bollard range is supplied in steel, stainless steel or polyurethane elastomer. Bollards are available with a round or square profile and meets the requirement of a wide variety of security needs, from preventing access to driveways to stopping ram raid attacks. The bollards are designed with ease of use in mind. It takes seconds to raise each one and lock it into place using its integral high security lock. When not in use the post is completely concealed, sliding discretely into the ground where it is covered by a steel flap.
Some of our telescopic bollards hold the Sold Secure grading “Security Posts Gold”, ensuring you have the best security bollards for the job!
PRODUCT CODES & OUTLINE SPECIFICATIONS:
Product Code |
Description |
Above Ground mm |
Below Ground mm |
Diameter mm |
|
TPR 576 | 7kg |
Driveway |
580 | 810 | Ø75 |
TPR 700 | 12kg |
Round |
670 | 960 | Ø90 |
TPR 800 | 14kg |
Round anti-ram raid |
670 | 960 | Ø90 |
TPR 390 | 13kg |
Round stainless steel anti-ram |
670 | 960 | Ø90 |
TPR 600 | 17kg |
Large round |
850 | 1140 | Ø115 |
TPR 300 | 13kg |
Large round stainless steel |
850 | 1140 | Ø115 |
TPS 700 | 13kg |
Square |
670 | 960 | 90 sq |
TPS 800 | 15kg |
Square anti-ram raid |
670 | 960 | 90 sq |
MATERIALS & FINISHES:
- Steel - galvanised finish
- Steel - polyester powder coated finish
OPTIONS:
- Lift assisted (TPR300 and TPR600)
INSTALLATION:
- Foundation depth is usually the same as root of bollard plus 110mm
- Minimum recommended foundation is Ø350mm
- Fill hole with just over 100mm of 20mm/12mm clean chippings
- Lower post on to chippings and check height
- Lid of post should be 5mm above ground level
- Position post central in bore hole and add more chippings until post stands unaided
- Withdraw sliding post and manoeuvre into vertical position using a spirit level
- Add more chippings - see specific instructions for amount
- Fill remainder of hole with 4:2:1 concrete mix and smooth off neatly to lid surround, leaving slight fallaway
- Finally check again vertical position using a spirit level and retract post back gently into ground & lock - LEAVE FOR 24 HOURS
- Keep fixed upper post clean during fitting procedure
Product Notes
Lift assisted TPR300 and TPR600
The lift assisted bollards come with the addition of a gas strut to reduce the lifting weight to approximately 4kg. Please note on the lift assisted version the depth below ground is increased to 1195mm.
Usage
When lowering the post do so in a controlled manner. Do not allow the post to free fall down into base.
Design changes
We reserve the right to change the design and specification on any item offered and, where possible, notification will be made.
Refer to e-brochure or PDF for full specification details and options.
Downloads
Address: 3rd Floor, Meridian House, Royal Hill, Greenwich, London SE10 8RD
Telephone: +44 (0)20 8378 3200
Email: sales@furnitubes.com
© Copyright Furnitubes International Ltd, 2010-2016